| Twins Turbo engine plumbing |
|
Twins Turbo can handel all of your Oil, Fuel, H20, sensor, A/N lines adapters and fittings need's. We use only the finest lines adapters and fittings on all of our shop project cars. We have also added a Brown and Miller Racing solutions crimping machine to the plumbing area of the shop. this will allow us to crimp fittings from -3 to -20 for the ultimate in weight savings and reliability. Brown and Miller also uses convoluted PTFE inner liner in all of it hoses. We have found this to be a great improvement over std rubber lining when dealing with leaded race fuel and methanol especially. All Brown and Miller fittings are a one-piece swept bend design with no welded, brazed or glued joints.
We also use re-useable fittings
from Brown and Miller, Aeroquipt and RedHorse ect when the weight and cost's
demand.
All A/N lines are press tested to 125 psi before
installation on the car
From the B+M site
" ProGold is the only performance racing hose
system available that has been engineered entirely to be the
lowest possible weight while exceeding virtually every operating condition seen
on a racecar: Pressure, Temperature, Vacuum, Flexibility, Physical Abuse,
Etc.
Safe and reliable, the inner hose is made of PTFE- a material unequalled for its high temperature performance and total fluid compatibility. Our unique convoluting method ensures maximum flexibility with unrivalled minimum bend radius figures with no variation in performance at high or low temperature and at high pressure or extreme vacuum. Convoluted hose also has the additional benefit of resisting collapse and flow restriction when pulled through tight bend radii.
|
